1. Inspection before starting1. Whether the wire drawing machine, quenching equipment and wire take-up machine are intact.2. Is the power supply, gas circuit, grease and ethanol complete?3. The manufacturing site should be cleaned without dirt, water…
If it is a new machine, the carburetor is not well adjusted. Old machines depend on whether the cylinder is pulling the cylinder; check the piston ring for serious wear; or replace the high pressure pack; the carburetor is not well adjusted.Solution: …
The appearance of the inverted wire drawing machine perfectly solves the output problems of some related industries, not only simplifies the work steps, but also greatly shortens the work cycle, the speed regulation is convenient and simple, significa…
Reasons and Solutions for Oxidation During the Wire Drawing Process of the Wire Drawing MachineFriends who have just entered the wire drawing industry, due to lack of experience, improper operation and other reasons, the phenomenon of surface oxidatio…
First, the operating requirements of the wire drawing machine1. Before using the wire drawing machine for processing, you must first understand and be familiar with the processing drawings and some related technical data, so as to avoid waste or scrap…
Precautions for using lawn mowers1. If you find that the grass is relatively long when mowing the grass, you should mow it in stages and stages (when the grass is relatively long, usually only 1/3 of the total length of the grass can be cut each time)…
1. First remove all the debris in the area that needs to be mowed, and then check the oil level of the engine, the amount of gasoline, the filtering performance of the air filter, the tightness of the screws, the tightness of the blade and the sharpne…
In this manufacturing process, the quality of the wire drawing machine is checked at various levels, but a good quality wire drawing machine does not mean that customers are not prone to problems in the whole process of application, perhaps due to poo…
1. There may be the following reasons for the difficulty in starting the lawn mower engine:a. No Gasoline - The solution to adding gasoline.b. The spark plug wire falls off - the solution for connecting the spark plug wire.The throttle switch is not i…
First, the wire drawing machine equipment to the operators job conditions:(1) The operator must hold the wire drawing machine operation qualification certificate, and it is strictly forbidden for unlicensed personnel to operate the machine.2. The oper…